Herunterladen Inhalt Inhalt Diese Seite drucken

Trimming The Helicopter - Reely Bravo III Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

h) Trimming the Helicopter
First start the transmitter, then the model.
Push the control stick with grating (pitch function) from the bottom position (engine off) forward carefully and observe
the response of your model. Shortly before the helicopter starts hovering, you can already determine in which direction
your model wants to move.
Tail trim:
If the helicopter wants to turn to the right with the nose of the fuselage, reduce speed and push the left side of the tail
function trim button repeatedly.
The transmitter emits a short confirmation tone at each push of a button. Since the trimming reacts to the
mixing ratio of the two drive motors, it is highly sensitive. Therefore, the button must be pressed repeatedly
until a clear change of the helicopter's flight behaviour is noticeable.
Push the Pitch stick carefully forward and check if the adjustment was sufficient. Keep repeating this procedure until
the helicopter no longer has any tendency to turn to the right. If the Tipp of the fuselage turns to the left, press the right
side of the trim button for the tail function.
Mode 2:
Mode 1:
42
Figure 20a
Figure 20b

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis