Maintenance And Care; Replacing The Rotor Blades - Reely MSP190 Bedienungsanleitung

13.

Maintenance and Care

Clean the exterior of the model and the remote control only with a soft, dry cloth or brush. Never use abrasive cleaning
agents or chemical solutions as these could damage the surfaces of the casings.
All moving parts have to be easily movable but there should not be a clearance in the bearing. The motor shafts with
the rotor shaft must be aligned perfectly straight and must not be eccentric.
When replacing mechanical parts use only original spares available from the manufacturer.
The spare parts list is located on our website www.conrad.com in the download section to the respective
product.
a) Replacing the Rotor Blades
If contact with an obstacle leaves visible danger on a
rotor blade (cracks or broken parts), the rotor blade
must be replaced.
First, the ball sockets of the linkage rods (1) must be
carefully removed from the rotor blade ball joints. Use
tweezers or suitable long-nosed pliers for this. Then the
retaining bolts (2) are removed.
Then the two rotor blades are separated and removed
from the rotor head.
When assembling the new rotor blades, first push the
two rotating pins (3) into the rotor head and then assem-
ble the two blades.
Turn in the retaining bolts again when the rotor blades
are correctly assembled.
Finally, attach the linkage rods again. Work with the
required care when pushing on the ball sockets to avo-
id damage to the rotor blade linkage or breaking off of
parts.
Figure 19
51