Trimming The Model Helicopter - Reely Beginner Falcon V2 Bedienungsanleitung

17.

Trimming the Model Helicopter

Push the control stick for the pitch function from the bottom position (engine off) forward carefully and observe the
response of your model. Shortly before the helicopter starts hovering, you can already determine in which direction
your model wants to move.
Tail trimming:
If the helicopter turns to the right with the tip of the fuselage, reduce the speed until the helicopter is standing safely
on its skids again. Now push the trim button for the tail function (also see figure 1, item 13) to the left for a few latching
clicks.
Then push the control stick for the pitch function forward carefully and check if the adjustment was sufficient. Keep
repeating this procedure until the helicopter no longer has any tendency to turn to the right.
If the tip of the fuselage turns to the left, press the trim slider for the tail function to the right.
Figure 28
88