Herunterladen Inhalt Inhalt Diese Seite drucken

Connecting The Voltage Supply; Initial Operation - MC Crypt 30 30 16 Bedienungsanleitung

Powermixer 4-kanal
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Connection

Connecting the voltage supply

The mains outlets to which the power mixer is connected must be easily accessible to
quickly separate the device from the mains voltage in case of an error.
Ensure that the voltage selector switch (16) on the rear of the device is in the correct
position for your supply voltage.
Note that the fuse used needs to be suitable for a power supply of 230 V~/50 Hz. If
you are operating your device with 120 V~/60 Hz, the fuse must be exchanged for a
fuse suitable for your power supply (see „Technical Data" for the correct values).
The power mixer and all connected devices must be turned off when connecting the
voltage supply.
Ensure that all the electrical connections and connection cables between the various
devices and any extension cables comply with regulations and also comply with the
operating instructions.
Connect the device connection plug of the power line to the mains connection (21) on the device.
Plug the mains cable into a proper wall socket.
With the switch POWER (15), you turn the power mixer on or off. In position „I" the device is turned
on, in position „0" it is turned off. When the device is switched on, the POWER indicator (8) lights
up.

Initial operation

Do not put the device into operation until your have familiarised yourself with the fun-
ctions and these operating instructions. Check again that all connections are correct.
Make sure that the connected loudspeakers and the power mixer are not overloaded.
The playback should not be distorted under any circumstances.
If the music signal is distorted in spite of the fact that the volume on the power mixer
is not at a high setting, and all the settings on the mixer are correct, then switch off
the mixer immediately and check all connections. If you can find no errors in the
connection, please contact a specialist.
Turn the controls MAIN (13) and TAPE (14) counter-clockwise to the minimal position.
Put the switches 48V (10) into the right position for your microphones (switch pressed > phan-
tom feed active, switch not pressed > phantom feed deactivated).
Turn all devices on that are connected to the power mixer.
Switch on the power mixer using the POWER (15) switch.
Put the control MAIN (13) to approx. central position.
Control the volume of the individual inputs with the controls LEVEL (1) so that there are no
major volume differences between the different audio sources.
Afterwards, the total volume is only set with the control MAIN (13).
Control the sound of the individual inputs with the controllers HI (3) and LO (4). The control Hi
(3) set the treble range, the control LO (4) the bass range.
With the control TAPE (14), set the volume of the input TAPE IN (19) on the back of the device.
24

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis