Speed Controller Reset - Reely 1:10 EP Carbon Fighter Bedienungsanleitung

• Function #11, green LED, 2 long and 1 brief flashes: Overheating protection
The overheating protection of the speed controller unit activates at +95°C, if this temperature is measured for longer
than 5 seconds. In this case the motor is switched off and the green LED flashes. Wait until the vehicle has cooled
down again before driving again.
For safety reasons, we recommend that you always activate the overheating protection.
When it is switched off, the speed controller unit can be destroyed by overheating, and your guarantee will
be void!

11.

Speed Controller Reset

With this function you can reset all of the settings adjusted when setting up the drive control unit to the
original factory settings.
• Switch on the transmitter, but leave the throttle/brake; do not move it.
• Switch on the speed controller (switch position "ON"). The vehicle should now be ready for operation; no LED is lit on
the speed controller.
• Hold down the setup button for 3 seconds.
The green and red LEDs on the speed controller light up together and then go back out.
• Switch off the speed controller (switch position "OFF"). All settings are now reset to the factory setting, see table in
chapter 10.
• Before driving your vehicle, you have to programme the neutral position and full throttle position for forwards/reverse
driving, see chapter 10. a).
Read chapter 10. b) for information on programming the special functions.
51