Reely 1:10 EP Carbon Fighter Bedienungsanleitung Seite 52

• Function #6: green LED, one long and one brief flash: Max. reverse speed
The maximum speed for reversing can be programmed with this function. Settable values are 25%, 50%, 75% und
100%. We recommend setting the reverse speed to a maximum of 50% so that the vehicle can be controlled better
in reverse driving.
If reverse driving has been switched off (see "Function #1"), this setting has no effect.
• Function #7: green LED, 1 long and 2 brief flashes: Minimum braking strength
This is where you can set the braking strength when the braking process begins (depending on the setting of the
transmitter throttle/braking lever).
The presetting is the same braking strength as the motor brake function (see "Function #2"), but values of 20% and
40% can also be programmed.
• Function #8, green LED, 1 long and 3 brief flashes: Neutral range (for neutral setting on transmitter)
This function can set the range or area "D" (see picture right)
that is recognised as the neutral position by the transmitter.
For the "D" area, the values of 6%, 9% and 12% of the lever
travel can be set.
A = Mechanic centre position of the throttle/brake lever
B = Full throttle
C = Full throttle reverse
D = Neutral range
E = Forwards range
F = Reverse range
• Function #9, green LED, one long and four brief flashes: Timing
Generally, higher values for timing increase the engine speed. Torque, however, decreases and power consumption
increases (lower driving time, engine and controller may overheat). The manufacturer has already chosen the best
settings for the engine built into the vehicle. It should only be changed by experienced model sportsmen.
Settable values are 0.00, 3.75, 7.50, 11.25, 15.00, 18.75, 22.50 and 26.25.
• Function #10, green LED, 2 long flashes: Motor type selection
This option is factory set to "Brushless-Motor" and cannot be adjusted.
50
A
D
E
B
C
F