Setting The Alignment - Reely 1:10 EP Carbon Fighter Bedienungsanleitung

b) Setting the Alignment
Wheel alignment (toe-in = figure "a", toe-out = figure "b") describes the
relation of the wheel level to the driving direction.
During the drive the tyres are pushed apart in the front because of the
rolling friction and this is why they are no longer precisely parallel to the
driving direction. To balance this, the tyres of the stationary vehicle can
be adjusted so that they point slightly inwards. This toe-in improves the
lateral cornering of the tyres and thus a more direct response to the
steering.
If a milder response to steering is desired, this can be achieved
accordingly by adjusting a toe-out, i.e. the wheels of the stationary
vehicle point outward. An alignment angle of 0° on the front axle ensures
the best driveability on almost any ground.
An alignment angle of more than 3° toe-in (a) or toe-out (b) will lead to handling problems and decreased
speed. It will also increase tyre wear.
The figure above shows a strongly over-emphasised setting that is only used for showing the difference
between toe-in and toe-out. If such a setting is used for the vehicle, it will be very difficult to control!
The wheel alignment setting for the rear axle is pre-determined by the manufacturer and cannot be changed.
For the front axle, alignment can be set by turning the
adjustment screw (A).
Because the adjustment screw has a left and right hand
thread at either end, it does not need to be dismantled
to be adjusted.
Turn both adjustment screws evenly (left
and right front wheel). Otherwise, you need
to adjust the trim of the transmitter or even
change the steering servo control (e.g.
adjust servo rod).
44
a
A
b
¦ ¦