Herunterladen Inhalt Inhalt Diese Seite drucken

Reely 1:10 EP Carbon Fighter Bedienungsanleitung Seite 50

Brushless 4wd rtr
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Flashing frequency of the red LED (currently set value for motor braking function):
1x briefly = 0%
2x briefly = 5%
3x briefly = 10%
4x briefly = 15%
• Press the set-up button at the speed controller briefly to select the next value. Check the flash signal of the red LED
Once the desired value is reached (for 40% the red LED will flash 1 x long and 3 x briefly), switch off the speed
controller unit. This concludes the programming. The value is saved.
If you wish to adjust other settings (e.g. low-voltage protection), proceed as described above.
Release the set-up button exactly when the green LED flashes for the corresponding function to be adjusted
(or the corresponding beep tone is heard, depending on the motor); an exact description of the individual
functions is given below.
Then press the set-up button briefly as often as required until the red LED flashes corresponding to the
desired setting value.
If the speed controller unit is switched off, the current setting and/or value will be saved.
The following functions are available:
#
Green LED blinks...
Function
(+ beep)
1
1x short
Drive function
2
2x short
Motorbrake
3
3x short
Undervoltage protection off
4
4x short
Start mode
5
1x long
Maximum brake power 25%
6
1x long, 1x short
Max. speed for driving
backwards
7
1x long, 2x short
Minimum brake power
8
1x long, 3x short
Neutral range
9
1x long, 4x short
Timing
10 2x long
Motor type
11 2x long, 1x short
Excess temp. protection +95°C
The speed controller is delivered programmed suitably for the vehicle. If you want to programme it on your
own, always check all settings or adjust them to your preferences.
Observe the description of the individual speed controller functions on the following pages before changing
the settings!
48
1x long= 20%
1x long, 1x briefly = 25%
1x long, 2x briefly = 30%
1x long, 3x briefly = 40%
1x short
Forward/brake Forward/brake/
0
Soft
25%
= Motorbrake 0%
6%
0.00
Brushless
Red LED blinks...
2x short
3x short 4x short
backward
5
%
10%
15%
2.6V/cell
2.8V/cell 3.0V/cell 3.2V/cell 3.4V/cell
Normal
Fast
Very fast
50%
75%
100%
50%
75%
100%
20%
40%
9%
12%
3.75
7.50
11.25
Off
1x long
1x long,
1x long,
1x short
2x short
20%
25%
30%
15.00
18.75
22.50
1x long,
3x short
40%
26.25

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis