Adjusting The Shock Absorbers; D) Mechanical Lowering - Reely 1:10 EP Carbon Fighter Bedienungsanleitung

c) Adjusting the Shock Absorbers
The shock absorbers at the front and rear vehicle axles can be mounted in different positions at the lower transverse
link (A) or the damper bridge (B).
At the upper shock absorber end (C), clips suitable for setting the spring-pre-tension
(included) can be inserted; see figure to the right.
Always set the shock absorbers for one axle evenly (at the left and right wheels of the
front or rear axle). Otherwise, driving behaviour will be influenced negatively.
Optional accessories (not included in the delivery; can be ordered separately) that can be used include
springs with a different stiffness or damper oil of a different viscosity for filling the shock absorbers.
Aluminium tuning shock absorbers that can be adjusted with a thumb wheel can also be used.

d) Mechanical Lowering

The vehicle can be lowered with one grub screw each in the lower
transverse link of the front axle (A) and rear axle (B).
When the grub screw is turned in further, the transverse link cannot
extend as far anymore. The vehicle is lowered with it.
Always set the grub screws for the transverse links of one axle evenly
(at the left and right wheels of the front or rear axle). Otherwise, driving
behaviour will be influenced negatively.
C
A
Front axle
B
B
C
A
Rear axle
A
B
45