Changing The Scan Code Set Of A Ps/2 Keyboard - Guntermann & Drunck miniMUX2 Installationsanleitung

Changing the scan code set of a PS/2 keyboard

NOTE:
This function is only relevant for computers which are connected to the
KVM switch using a PS/2 KVM connection cable.
If a key is pressed on the PS/2 keyboard, the keyboard processor sends a data packet
that is called scan code. The two common scan code sets (sets 2 and 3) contain dif-
ferent scan codes.
The KVM switch interprets all inputs of the PS/2 keyboard with scan code set 2.
If the pipe ("|") cannot be entered or if the arrow keys of the keyboard do not work
as expected, it is recommended to switch to scan code set 3.
How to change the setting of the scan code set:
1. Press Hotkey+Backspace
If the hotkey delay is active, press the key combination for seven seconds.
2. Press one of the setup keys listed below to activate a particular scan code set:
 enables scan code set 2 for PS/2 keyboard inputs
2
3  enables scan code set 3 for PS/2 keyboard inputs
3. Restart the KVM switch. After the restart, the keyboard is initialised and
the selected scan code set does apply.
1. Use the terminal emulator to establish a connection to the KVM switch
and connect the serial data cable to the Service socket.
2. Use the Arrow
3. Press the Space
2  enables scan code set 2 for PS/2 keyboard inputs
3  enables scan code set 3 for PS/2 keyboard inputs
4. Press the S key to save your settings.
5. Restart the KVM switch. After the restart, the keyboard is initialised and
the selected scan code set does apply.
(default: Ctrl+Backspace
or Arrow keys to select the
key (repeatedly) to activate a particular scan code set:
Configuration
) to enable the setup mode.
PS/2 Scancode Set entry.
G&D miniMUX2 · 26