Changing The Single Hotkey - Guntermann & Drunck miniMUX2 Installationsanleitung

Changing the single hotkey

Press the hotkey and the
KVM switch. Pressing the hotkey and the select key simultaneously enables the
switching of channels.
If an application program or another G&D device uses the same hotkey within the
cascade, the hotkey can be changed.
NOTE:
The single hotkey
How to change the current hotkey:
1. Press the Hotkey+Backspace
enable the setup mode.
If the hotkey delay is active, press the key combination for seven seconds.
2. Press one of the setup keys listed below to enable a certain hotkey:
 enables Ctrl hotkey
Ctrl
Alt  enables Alt hotkey
 enables Alt Gr hotkey
Alt Gr
 enables Win hotkey
Win
Shift  enables Shift hotkey
1. Use the terminal emulator to establish a connection to the KVM switch
and connect the serial data cable to the Service socket.
2. Use the
Arrow
3. Press the Space
Ctrl  enables Ctrl hotkey
 enables Alt hotkey
Alt
Alt Gr  enables Alt Gr hotkey
Win  enables Win hotkey
 enables Shift hotkey
Shift
4. Press the S key to save your settings.
Backspace key simultaneously to start the setup mode of the
Ctrl is preset at default.
(default:
or keys to select the
Arrow
key (repeatedly) to enable a certain hotkey:
Ctrl+Backspace ) key combination to
entry.
Hotkey
G&D miniMUX2 · 18
Configuration