Configuration
Changing the double hotkey
If the use of double hotkeys is enabled (see page 17), press the double hotkey and the
Backspace
key simultaneously to start the setup mode of the KVM switch. Switching
of channels takes place by pressing the double hotkey and a select key at the same
time.
If an application program or another G&D device uses the same hotkey within the
cascade, the hotkey can be changed.
How to change the current double hotkey:
1. Requirement: enabling of the double hotkeys (see page 17).
2. Press
Double hotkey+Backspace
setup mode.
If the hotkey delay is active, press the key combination for seven seconds.
3. Press one of the setup keys listed below to activate the desired double hotkey:
Ctrl
enables Ctrl+Shift double hotkey
Alt
enables Alt+Shift double hotkey
Alt Gr
enables Alt Gr+Ctrl double hotkey
Win
enables Win+Ctrl double hotkey
Shift
enables Shift+Win double hotkey
1. Requirement: enabling of the double hotkeys (see page 17).
2. Use the terminal emulator to establish a connection to the KVM switch
and connect the serial data cable to the Service socket.
3. Use the
Arrow
4. Press the
Space
Ctrl+Shift
Alt+Shift
Alt Gr+Ctrl
Win+Ctrl
Shift+Win
5. Press the
S
19 · G&D miniMUX2
or
Arrow
keys to select the
key (repeatedly) to enable the desired double hotkey:
enables Ctrl+Shift double hotkey
enables Alt+Shift double hotkey
enables Alt Gr+Ctrl double hotkey
enables Win+Ctrl double hotkey
enables Shift+Win double hotkey
key to save your settings.
(default:
Ctrl+Shift+Backspace
Hotkey
) to enable the
entry.