Switching Via Step Keys - Guntermann & Drunck miniMUX2 Installationsanleitung

Switching via step keys

IMPORTANT: The use of step keys is disabled in the default settings. Information on
how to enable this function can be found on page 24.
Insted of using select keys to switch to a computer that is connected to the KVM switch,
you can use step keys to switch the channels in ascending or descending order.
IMPORTANT:
The active step keys depend on the selected select keys. The following
table lists the step keys depending on the active select keys.
Select keys
1 ... 2
NUM 1 ... 2
A ... B
F1 ... F2
How to use step keys to switch to a certain channel:
1. Press
Hotkey+»Back« step key
console keyboard.
»Back« step key
9
NUM 9
I
F9
or
Hotkey+»Forward« step key
Switching between the computers
»Forward« step key
0
NUM 0
K
F10
on the 
G&D miniMUX2 · 10