Receiving Group Calls In Idle; Receiving Group Calls During Ongoing Group Calls; Dynamic Group Number Assignment (Dgna); Dgna Reception - Motorola MTM800 FuG Bedienungsanleitung

Note: To cancel making a group call, do one the following actions before the talk permit is granted
(depending on your service provider's settings):
• Release the PTT button.
• Press the END key (default).
When the call is canceled, your radio displays Call Cancelled message (if configured by your service
provider).

Receiving Group Calls in Idle

Procedure:
1 The radio receives a Group Call.
Note: The incoming Group Call is signalled by a Receiving Group Call tone.
2 To respond, press and hold the PTT button.

Receiving Group Calls during Ongoing Group Calls

While in active Group Call, your radio receives a Group Call with a higher priority.
One of the following occurs:
• Your radio is forced to end the current group call and automatically join the incoming one.
• Your radio displays incoming group call screen with options:
- Join — ends current Group Call and starts the incoming one.
- End — cancels the incoming Group Call.

Dynamic Group Number Assignment (DGNA)

DGNA allows the network operator to dynamically manage talkgroups on your radio over the air interface. Using
DGNA, the network operator can:
• Add talkgroups.
• Attach or select newly added talkgroups.
• Delete talkgroups.
• Modify parameters of existing talkgroups.
All the above operations are performed by transmitting data to your radio.

DGNA Reception

When a DGNA message is received, your radio plays a tone and displays a message Talkgroup list updated. If
enabled by your service provider, your radio displays all added and deleted talkgroup list.
When your service provider deletes (de-assigns) the currently selected talkgroup, depending on the settings, the radio
can perform one of the following actions:
• Enter the "No Group" state – the radio does not attach to any talkgroup automatically.
• Attach to the last selected TMO talkgroup. If the last selected TMO talkgroup is not available (it was deleted), the
radio enters the "No Group" state.
• Attach to a default talkgroup configured by your service provider. If the default talkgroup is not available (it was
deleted), the radio enters the "No Group" state.
At each talkgroup change, an appropriate notification is shown on the display.
If the DGNA message is received to delete all talkgroups, your radio displays All Talkgroups Deleted. To exit the
DGNA display, you can use the BackS key or the E key.
OFT ND
Modes | 43
| | Send Feedback