Packet Data; Tetra Enhanced Data Services (Teds); Viewing Data Statistics - Motorola MTM800 FuG Bedienungsanleitung

3 Select one of the following:
• Position – displays detailed information on radio's current position: time, N (latitude), E (longitude), H
(height), Sats Used (a number of tracked satellites), B (bearing), HS (horizontal speed), LC (level of
confidence).
• Power – displays detailed information on a particular satellite: PRN code, Status, Mode, C/N (carrier-to-
noise ratio).
• Version – displays detailed information on GPS version: SW (software version), HW (hardware version),
ASIC (application-specific integrated circuit), RC (release code).

Packet Data

The Packet Data (PD) Service allows you to transfer data in a TETRA system using the Internet Protocol (IP).
Note: To transfer data from a standard computer over the air, connect the computer via the data cable
PMKN4104 with your radio. Your service provider has to setup additional applications on your computer.
If set up by your service provider it is possible to accelerate the transmission by using the Multi-Slot Packet Data
(MSPD) Service.
Note: This is a selling feature.

TETRA Enhanced Data Services (TEDS)

TETRA Enhanced Data Services (TEDS) is an enhancement of the Packet Data feature and allows for increased
speed of data transfer.
When TEDS is enabled, an appropriate icon is displayed in the status icon area. The icon is visible even if an
infrastructure does not support TEDS – in such a situation the data is transferred by using the standard Packet Data.
Note: This is a selling feature.

Viewing Data Statistics

Procedure:
1 From the home screen, press the
2 Select Packet Data.
Note: Data services are only available in TMO Mode. The data option must be set to Voice & Data or
Data Only.
3 Select one of the following:
• Sent Data — the number of KBs sent and throughput since current Packet Data activation is displayed.
• Received Data — the number of KBs received and throughput since current Packet Data activation is
displayed.
• Bandwidth — active data session percentage is shown.
• Failed Transfer — the percentage of failed sent/received packets.
Note: N.A. — standby packet data session.
key.
MENU
Main Menu | 101
| | Send Feedback