Phone/Pabx Speed Dial; Using The Phone/Pabx Speed Dial; Ms-Isdn; Dtmf Overdial - Motorola MTM800 FuG Bedienungsanleitung

108 | Features

Phone/PABX Speed Dial

This feature allows you to dial Phone/PABX by a shortened number of up to three digits instead of the full number.
The Phone/PABX Speed # number is assigned when the dialed number is added in the contact list.
Note: This feature is available only in TMO Mode.

Using the Phone/PABX Speed Dial

Procedure:
1 From the home screen, enter the predefined Phone/PABX speed dial number and # key.
2 Press S key.
END

MS-ISDN

This feature adds to the radio ISDN number. You can choose between MS-ISDN and ISSI to address the call, send
the message or pre-defined templates. It works for both simplex and duplex calls, based on the assigned ISDN
number.

DTMF Overdial

This feature allows you to communicate with an automated answering device (for example, the voice mail or
answering machine) during an on-going private, phone or PABX call.
While in an on-going private, phone or PABX call, press the DTMF keys (0-9, *, #). When pressed, the DTMF key
sounds a tone and the entered digit is displayed on the screen.

Short Number Dial

This feature allows you to dial part of the full number of the person you wish to call. Your radio automatically
completes the number.
Example: Your radio number is 4282564.
1 Dial 564 (instead of 4282564, the full number).
2 To place the call, press the PTT button or the S

Dual Control Head

This feature allows you to use two control heads with one transceiver. The control heads are of equal importance and
have almost identical functionality, the only difference is second PTT installed on the Telephone Style Control Head.
In Dual Control Head mode, when you press M
CH2. Almost all menu items inside them are common for both control heads, except for: Set Volume, Accry Setup,
Send Feedback | |
key.
END
→ Setup you can choose between two control heads: CH1 and
ENU