Group Setup; Standard Home Group; Operations Parameters; Scan - Motorola MTM800 FuG Bedienungsanleitung

92 | Main Menu

Group Setup

This sub-menu allows you to set the operation parameters, scanning and my groups folder.

Standard Home Group

This menu item allows you to configure the standard home group to be used during start up and when changing
modes: TMO –> DMO and TMO –> Repeater.

Operations Parameters

When and where to use: If you want to define the radio mode and the talkgroup at the radio startup, and when
changing modes TMO->DMO and TMO-> Repeater.
Procedure:
1 From the home screen, press the
2 Select Group Setup → Operations Parameters.
3 Select Startup. Select one of the following:
• TMO – the radio powers up in TMO mode.
• DMO – the radio powers up in DMO mode.
• Last Selected – the radio powers up in the mode it was in when last powered down.
4 Select Home Group Startup. Select one of the following:
• Last Selected – the radio enters the TMO/DMO talkgroup which was last selected before power down.
• Home Group – the radio enters the Home Group (TMO or DMO) at power up, depending on the radio mode
entered at power up.
5 Select HGr TMO->DMO/Rep. Select one of the following:
• Last Selected – when changing modes the radio enters the DMO Talkgroup last selected, i.e. the DMO Talk
Group active last time the Radio was in DMO Mode. If Group Mappings are configured, they will take
precedence and the DMO Talkgroup mapped to the current TMO Talkgroup is used.
• Group Mappings – when changing modes the radio enters the DMO Home Group unless a Group Mapping is
configured. If Group Mappings are configured, they will take precedence and the DMO Talkgroup mapped to
the current TMO Talkgroup is used.
• Home Group – when changing modes the radio enters the DMO Home Group, ignoring possible group
mappings.
6 Select TMO Home Group – configures the TMO Home Group/Home Folder.
7 Select DMO Home Group – configures the DMO Home Group.

Scan

This menu item allows you to activate/deactivate scanning, view the active scan list, and edit the scan lists. This
feature is available only for the TMO Mode. Your radio joins any group call as long as this group is defined in the
scan list and scan is turned on.

Activating Talkgroup Scanning

When and where to use: If you want to monitor any TMO Group Call in the defined talkgroup list.
Procedure:
1 From the home screen, press the
2 Select Group Setup → Scan → Scanning.
Send Feedback | |
key.
MENU
key.
MENU