Software- Requirements - Siemens Simatic net CP-5412 Installationsanleitung

Installation Instructions CP-5412/Windows NT
1.2

Software- Requirements

Operating System
Interrupt
Dual-port RAM
Address Area
SIMATIC NET-CD
Memory
Requirements on
the Hard Disk
48
The product requires Windows NT version 4.0 or higher as the
operating system.
Each CP 5412 (A2) requires one interrupt for operation. This can be
set in the software. Make sure that one of the following interrupts on
your system is free for the CP 5412 (A2):
IRQ 5, IRQ 10, IRQ 11, IRQ 12, IRQ 15
You should also make sure that the interrupt you selected is not being
used already by other components in your system.
Each CP 5412 (A2) occupies a memory area of 16 Kbytes during
operation. The location of the area is set in the configuration program.
Make sure that the memory you select is not used by any other
component in your system.
On some computer models with a memory configuration greater
than 16 Mbytes, access to the ISA bus is only possible in areas
D 0000 D FFFF or E 0000
H - H
settings in the BIOS of your computer. For more information,
read the BIOS description of your computer.
The program package is shipped along with other
SIMATIC NET products on a CD-ROM.
The red diskette (key diskette) contains the authorization information
for the program package and is not read only.
During installation, the space required by the software package is
displayed and the destination drive is checked to make sure there is
sufficient space.
E FFFF . You may have to change
H - H
Installationsanleitung CP-5412/Windows NT
C79000-B8274-C375-02