Continuous Recording; When The Camcorder Is In The Recording Pause Mode; Continuous Recording In Other Cases - Sony DNV-5 Bedienungsanleitung

4-2 Recording
Cassette control buttons
During recording, the cassette control buttons (EJECT,
REW, F FWD, PLAY, STOP) have no effect.

4-2-2 Continuous Recording

If the camcorder is in the recording pause mode,
simply pressing the VTR START button on the video
camera or the VTR button on the lens continues
recording at exactly the next frame.
In other cases, you first need to position the tape at an
appropriate point.
When the camcorder is in the recording
pause mode
Pressing the VTR START button on the video camera
or the VTR button on the lens positions the tape at the
appropriate point automatically. However, the time
taken before recording starts depends on the setting of
the VTR SAVE/STBY switch on the video camera.
• If the VTR SAVE/STBY switch is in the SAVE
position, it takes about 4 seconds before recording
starts.
• If the VTR SAVE/STBY switch is in the STBY
position, recording starts immediately. However, just
after the switch position is changed from SAVE to
STBY, it takes about 4 seconds before recording
starts.
If you turn off the DNV-5 during a
recording pause
Follow the procedure below to continue recording.
2
3
Continuous recording after turning off the DNV-5
during a recording pause
4-4(E)
Chapter 4 Recording and Playback
1
1
Turn on the DNV-5 again.
2
Press the RET button on the lens.
The tape is positioned at the appropriate point.
Note, however, that this function works only for
continuously recorded material or consecutively
joined segments totaling at least 4 seconds in
length.
3
Press the VTR START button on the video camera
or the VTR button on the lens to start recording.

Continuous recording in other cases

After rewinding or fast forward, after removing the
cassette, or on a tape that has been partially recorded,
you can obtain a continuous recording by following
the procedure below.
3
4
Continuous recording after rewinding or fast forward, after removing
the cassette, or on a tape that has been partly recorded
1
Looking in the viewfinder, press the PLAY button
to start playback.
2
Press the STOP button at the desired point to begin
recording. To continue from the end of recording
already on the tape, press the STOP button
immediately after the end of the previous recording
(within 0.5 seconds).
3
Press the RET button on the lens.
The tape will rewind and will be positioned at the
desired point to continue recording in about 7
seconds.
4
Press the VTR START button on the video camera
or the VTR button on the lens to start recording.
21