Audio Functions - Sony DNV-5 Bedienungsanleitung

2-3 Audio Functions

1 CH-1/CH-2 (audio channel 1 and channel 2
recording level) controls
These controls adjust the audio level of channels 1 and
2 when you set the AUDIO SELECT CH-1/CH-2
switches to MANUAL.
2 AUDIO SELECT CH-1/CH-2 (audio channel-1
and channel-2 select) switches
These switches set the audio level adjustment for
channels 1 and 2 to MANUAL or AUTO.
3 AUDIO IN (audio input) switches
These switches select the audio input signals for audio
channels 1 and 2. The input signal source is either:
FRONT: The input signal source is the camera's
MIC IN connector.
REAR: The input signal source is the AUDIO IN
CH-1/CH-2 connectors.
WIRELESS: The signal source is the input signal
from a WRR-855A UHF Synthesized Tuner Unit
(not supplied).
The audio input signals from the camera's MIC IN
connector and the wireless microphone are always
recorded on audio channels 3 and 4, respectively,
whether or not they are recorded on audio channels 1
and 2 in accordance with the setting of this switch.
For more information, refer to the Maintenance Manual.
1 CH-1/CH-2 controls
2 AUDIO SELECT CH-1/CH-2 switches
3 AUDIO IN switches
4 AUDIO OUT connector
5 AUDIO IN CH-1/CH-2 connectors and LINE/MIC/
+48 V ON selectors
Audio functions (1)
4 AUDIO OUT (audio output) connector (XLR
type, 5-pin, male)
This connector outputs the stereo sound signals.
Using a CCXA-53 Audio Cable (not supplied), you
can convert from a 5-pin connection to two 3-pin
connections.
5 AUDIO IN CH-1/CH-2 (audio channel 1 and
channel 2 input) connectors (XLR type, 3-pin,
female) and LINE/MIC/+48 V ON (line input/
microphone input/external power supply +48 V on)
selectors
These are the audio input connectors for channels 1
and 2, to which you can connect a microphone or other
audio sources.
The LINE/MIC/+48 V ON selectors select the audio
input signal source connected to these connectors, as
follows:
LINE: Line input audio equipment
MIC: A microphone with internal batteries
+48 V ON: A microphone with an external power
supply system
Chapter 2 Locations and Functions of Parts and Controls
2-3(E)