Sony DNV-5 Bedienungsanleitung Seite 60

6-1 Testing the Camcorder Before Shooting
7
Turn on the LCD LIGHT switch, and check that
the display panel is illuminated.
8
Hold down the REW button to rewind the tape for
a while, then press the PLAY button. Check that
the rewind and playback functions operate
normally.
9
Press the STOP button and press the F FWD
button. Check that the fast forward function
operates normally.
(2) Testing the automatic audio level
adjusting functions
1
Set the AUDIO SELECT CH-1/CH-2 switches to
AUTO.
2
Set the AUDIO IN switches to FRONT.
3
Aim the video camera microphone connected to
the MIC IN connector at a suitable sound source.
Check that the level indications for both channels
correspond to the sound level.
(3) Testing the manual audio level
adjusting functions
1
Set the AUDIO IN switches to FRONT.
2
Set the AUDIO SELECT CH-1/CH-2 switches to
MANUAL.
3
Adjust the MIC AUDIO LEVEL control on the
front of the video camera. Check that the level
indications increase as the control is turned
counterclockwise.
(4) Testing the earphone and speaker
1
Turn the MONITOR control and check that the
speaker volume changes accordingly.
2
Connect an earphone to the EARPHONE jack.
Check that the speaker sound is cut off and that
you can hear the sound from the microphone in the
earphone.
6-2(E)
Chapter 6 Maintenance
3
Turn the MONITOR control and check that the
earphone volume changes accordingly.
(5) Testing external microphones
1
Connect external microphones to the AUDIO IN
CH-1/CH-2 connectors.
2
Set the LINE/MIC/+48V ON selectors to MIC or
+48V ON in accordance with the microphone type.
3
Set the AUDIO IN switches to REAR.
4
Aim the microphones at a sound source.
5
Check that the audio level meter in the display
panel reflects the changing sound level.
Alternatively, with a single microphone, check each
channel in turn.
(6) Checking the functions of the user bits
and time code
1
Set the user bits as required.
For more information, see Section 5-2-1 "Setting the
User Bits" (page 5-2(E)).
2
Set the time code.
For more information, see Section 5-2-2 "Setting the
Time Code" (page 5-2(E)).
3
Set the F-RUN/SET/R-RUN switch to R-RUN.
4
Press the VTR START button on the video
camera, and check that the tape starts and that the
counter indication changes.
5
Press the VTR START button again, and check
that the tape stops and that the counter indication
also stops changing.
6
Set the F-RUN/SET/R-RUN switch to F-RUN, and
check that the counter indication changes
regardless of whether the tape is running.
7
Set the DISPLAY switch to DATA and the DATA
DISPLAY switch to U-BIT, and check that the
user bits data is displayed.