Denon AVR-3803 Bedienungsanleitung Seite 28

ENGLISH
Playing audio sources (CDs and DVDs)
The AVR-3803 is equipped with three 2-channel playback modes exclusively for music.
Select the mode to suit your tastes.
1
PURE DIRECT mode
In this mode, the music is played with an
extremely high level of sound quality.
When this mode is set, all the video-related
circuits are turned off so that music signals can
be reproduced with high quality.
analog mode is selected, the digital processing
circuitry is also turned off to achieve analog
sound with even higher purity. (See NOTES)
• The PURE DIRECT indicator lights.
Light
(Main unit) (Remote control unit)
2
DIRECT mode
Use this mode to achieve good quality 2-
channel sound while watching images. In this
mode, the audio signals bypass such circuits as
the tone circuit and are transmitted directly,
resulting in good quality sound.
(Remote control unit)
3
STEREO mode
Use this mode to adjust the tone and achieve
the desired sound while watching images.
(Remote control unit)
28
When an
1
1
NOTES:
• The system setup function cannot be used when
the PURE DIRECT mode is set. To use the
system setup function, cancel the PURE DIRECT
mode.
• The ZONE2 video output is not output in the
PURE DIRECT mode.
• The channel level and surround parameters in the
PURE DIRECT mode are the same as in the
DIRECT mode.
• When the PURE DIRECT button is pressed or the
SELECT knob is turned while in the PURE
DIRECT mode, the PURE DIRECT mode is
cancelled.
• The subwoofer's channel level must be set to
"OFF" in order to turn off the digital circuit in the
PURE DIRECT mode.
After starting playback
[1] Adjusting the sound quality (TONE)
The tone control function will not work in the Direct mode.
1
The tone switches as follows each time the
TONE CONTROL button is pressed.
(Main unit)
2
With the name of the volume to
be adjusted selected, turn the
SELECT knob to adjust the level.
3
2
• To increase the bass or treble: Turn the control
clockwise. (The bass or treble sound can be
increased to up to +10 dB in steps of 2 dB.)
• To decrease the bass or treble: Turn the
control counterclockwise. (The bass or treble
sound can be decreased to up to –10 dB in
steps of 2 dB.)
[2] Listening over headphones
1
Plug the headphones' plug into
the jack.
Connect the headphones to
the PHONES jack.
The pre-out
(including the
output) is automatically turned off when
headphones are connected.
[3] Turning the sound off temporarily (MUTING)
1
Use this to turn off the audio
output temporarily.
Press the MUTING button.
Cancelling MUTING
mode.
Press the MUTING button again.
BASS TREBLE
SELECT
(Main unit)
3
If you do not want the bass and treble to be
adjusted, turn on the tone defeat mode.
(Main unit)
PHONES
1
output
speaker
1
NOTE:
To prevent hearing loss, do not raise the volume level
excessively when using headphones.
(Remote control unit)
2 3 1
The signals do not pass
through the bass and treble
adjustment circuits, providing
higher quality sound.
1