Denon AVR-3803 Bedienungsanleitung Seite 24

ENGLISH
(2) Resetting "learned" buttons
1
Press the power ON/SOURCE button and the
OFF button at the same time.
• "PRE" appears on the remote control unit's
display.
2
Use the • and ª cursor buttons to display
"RST" on the remote control unit's display, then
press the ENTER button.
• "PRE" is displayed.
3
Use the • and ª cursor buttons to display
"LRN" on the remote control unit's display, then
press the ENTER button.
• "SEL" is displayed.
4
Use the • and ª cursor buttons to select the
mode of the button to be reset, then press the
ENTER button.
• The LCD's back light flashes during the
resetting operation, and when the operation is
completed, "OK" is displayed and the set
returns to the normal operating mode.
24
1 1
DVD
2, 3, 4
2, 3, 4
(3) Resetting the system call buttons
1
Press the power ON/SOURCE button and the
OFF button at the same time.
• "PRE" appears on the remote control unit's
display.
2
Use the • and ª cursor buttons to display
"RST" on the remote control unit, then press
the ENTER button.
• "PRE" appears on the remote control unit's
display.
3
Use the • and ª cursor buttons to display
"CALL" on the remote control unit's, then press
the ENTER button.
• "SEL" appears on the remote control unit's
display.
4 Press the • and ª cursor buttons to select the
system call setting to be reset.
The remote control unit's display switches
as shown below each time the • and ª
cursor buttons are pressed.
CALL 1
CALL 2
1 1
DVD
2, 3, 4
2, 3, 5
5
To reset CALL 1 or CALL 2, select "CALL 1" or
"CALL 2", then press the ENTER button.
• The LCD's back light flashes during the
resetting operation, and when the operation
is completed, "OK" is displayed and the set
returns to the normal operating mode.