Denon AVR-3803 Bedienungsanleitung Seite 11

3
Set whether or not speakers
are connected and, if so, their
size parameters.
• To select the speaker
• To select the parameter
4
Press the ENTER button to finalize the setting.
NOTE:
• Select "Large" or "Small" not according to the actual size of the speaker but according to the speaker's
capacity for playing low frequency (bass sound below frequency set for the Crossover Frequency mode and
below) signals. If you do not know, try comparing the sound at both settings (setting the volume to a level
low enough so as not to damage the speakers) to determine the proper setting.
• Parameters
Large.................Select this when using speakers that have sufficient performance for reproducing bass
sound below the frequency set for the Crossover Frequency mode.
Small .................Select this when using speakers that do not have sufficient performance for reproducing
bass sound below the frequency set for the Crossover Frequency mode. When this is set,
bass sound with a frequency below the frequency set for the Crossover Frequency mode
is sent to the subwoofer.
When this setting is selected, low frequencies of below the frequency set for the Crossover
Frequency mode are assigned to the subwoofer.
None...... ..........Select this when no speakers are installed.
Yes/No... ...........Select "Yes" when a subwoofer is installed, "No" when a subwoofer is not installed.
2spkrs/1spkr .....Set the number of speakers to be used for the surround back channel.
If the subwoofer has sufficient low frequency playback capacity, good sound can be achieved even when
"Small" is set for the front, center and surround speakers.
For the majority of speaker system configurations, using the Small setting for all five main speakers and
Subwoofer On with a connected subwoofer will yield the best results.
Selecting the surround speakers for the different surround modes
This screen is displayed when using both surround speakers A and B.
• At this screen preset the surround speakers to be used in the different surround modes.
1
Center Sp.
Front Sp.
Subwoofer
Surround Sp. A
Surround back Sp.
Surround Sp. B
2
Speaker type setting when using both surround speakers A and B
If "Small" is set for either surround speakers A or B, the output is the same as when "Small" is set for both
A and B.
Setting the crossover frequency and low frequency distribution when
playing Dolby Digital and DTS signals
• Set the crossover frequency and subwoofer mode according to the speaker system being used.
1
2
When either "Large" or "Small" has been set for both
speakers A and B on the System Setup Menu (when
using both A and B surround speakers), the surround
speaker setting screen appears.
Select the surround speakers to be used in the different
surround modes.
• To select the surround mode
• To select the surround speaker
A: When using surround speakers A
B: When using surround speakers B
A+B: When using both surround speakers A and B
Enter the setting.
When "Front" is set to "Large" and "Subwoofer" is set to "Yes", the set switches to the
subwoofer mode.
Select the "Crossover Frequency" mode.
Select the Frequency.
Select the "Subwoofer Mode".
Select the setting.
ENGLISH
11