Punch Through - Denon AVR-3803 Bedienungsanleitung

ENGLISH
System call
The included remote control unit is equipped with a system call function allowing a series of remote control
signals to be transmitted by pressing a single button.
This function can be used for example to turn on the amplifier's power, select the input source, turn on the
monitor TV's power, turn on the source component's power and set the source to the play mode, all at the touch
of a button.
(1) System call buttons
Up to 10 signals each can be stored at the
"CALL1" and "CALL2" buttons.
(2) Storing system call signals
1
Press the power ON/SOURCE button and the
OFF button at the same time.
• "PRE" appears on the remote control unit's
display.
2 Use the • and ª cursor buttons to display
"CALL" on the remote control unit, then press
the ENTER button.
• Display "SEL" on the remote control unit's
display.
3 Use the • and ª cursor buttons to display the
name of the device you want to register at the
system call button, then press the ENTER
button.
• Display "KEY" on the remote control unit's
display.
The display switches as shown below each
time the • and ª cursor buttons are
pressed.
AMP ZONE2
CD CDR MD
TV CABLE DBS VCR2 VCR1
It is also possible to select the mode directly
using the mode buttons.
22
1
1
DVD
5
2, 3
7
4 Press the button you want to register. "SET" is
displayed and the button is registered.
• Once the button is registered, the "KEY"
indicator reappears and the next button can be
registered.
5 The mode can be switched by pressing a mode
button while the "KEY" indicator is lit.
Press the ENTER button to turn the "KEY"
indicator back on, setting the registration
standby mode.
TAPE DVD
VDP
6 Repeat steps 4 and 5 to register the desired
buttons.
7
Press the "CALL1" or "CALL2" button while the "KEY" indicator is lit to register the
signals at the system call button.
• "OK" is displayed and the set returns to the normal operating mode.
NOTES:
• The remote control signals of the buttons pressed while registering the system call signals are emitted, so
be careful not to operate the components accidentally (cover the remote sensors, for example).
• If you exceed the number of signals that can be registered, "FULL" appears on the remote control unit's
display and only the number of signals that can be registered are registered.
(3) Using the system call function
1 Press the button at which the system call signals have been stored.
• The stored signals are transmitted successively.
1

Punch Through

(1) Punch through button
Buttons used in the CD, CDR, TAPE, DVD, VDP,
VCR1 and VCR2 modes can be assigned to the
buttons shown on the diagram at the right which
are not normally used in the AMP, TV, DBS and
CABLE modes.
For example, when the CD mode is set to the
punch through mode in the AMP mode, the CD
mode's PLAY, STOP, MANUAL SEARCH, AUTO
SEARCH, PAUSE and DISC SKIP buttons' signals
are sent in the AMP mode.
(2) Making the punch through setting
2, 3
1
Press the power ON/SOURCE button and the
OFF button at the same time.
• "PRE" appears on the remote control unit's
display.
2 Use the • and ª cursor buttons to display
"PUNCH" on the remote control unit, then
press the ENTER button.
• "SEL" appears on the remote control unit's
display.
1 1
DVD
(1)
2, 3, 4
2, 3, 4