Operation; Before Operating; Playing The Input Source - Denon AVR-3803 Bedienungsanleitung

ENGLISH
9

OPERATION

Before operating

1
Refer to "CONNECTIONS" (pages 4 to 8) and
check that all connections are correct.
2
Select "AMP" using the AMP button.
(only when operating with the remote control
unit)
(Remote control unit)
3
Turn on the power.
Press the POWER operation switch (button).
ON/STANDBY
(Main unit) (Remote control unit)
• ¢ ON/STANDBY
The power turns on and "ON/STANDBY"
indicator is light.
Several seconds are required from the time
the power operation switch is set to the "¢
ON/STANDBY" position until sound is output.
This is due to the built-in muting circuit that
prevents noise when the power switch is
turned on and off.
Set the power operation switch to this
position to turn the power on and off from the
included remote control unit (RC-922).
• £ OFF
The power turns off and "ON/STANDBY"
indicator is off.
In this position, the power cannot be turned
on and off from the remote control unit (RC-
922).
26
3
AMP
2
Lights

Playing the input source

1 1
2
1
Select the input source to be played.
Example: CD
FUNCTION
3
(Main unit)
To select the input source
when ZONE2/REC OUT or
TUNING PRESET is selected,
press the SOURCE button
then operate the input function
selector.
2
Select the input mode.
• Selecting the analog mode
Press the ANALOG button to switch to the
analog input.
(Main unit)
• Selecting the external input (EXT. IN) mode
Press the EXT. IN (on the EXT. IN button on
the remote control unit) to switch the external
input.
(Main unit)
• Selecting the AUTO, PCM and DTS modes
The mode switches as shown below each
time the INPUT MODE button is pressed.
AUTO
(Main unit)
5
1
3
(Remote control unit)
Input mode selection function
Different input modes can be selected for the different
input sources. The selected input modes for the separate
input sources are stored in the memory.
(Main unit)
q AUTO (auto mode)
In this mode, the types of signals being input to the
digital and analog input jacks for the selected input
source are detected and the program in the AVR-
3803's surround decoder is selected automatically
upon playback. This mode can be selected for all input
sources other than PHONO and TUNER.
The presence or absence of digital signals is detected,
the signals input to the digital input jacks are identified
and decoding
automatically in DTS, Dolby Digital or PCM (2 channel
stereo) format. If no digital signal is being input, the
(Remote control unit)
analog input jacks are selected.
Use this mode to play Dolby Digital signals.
w PCM (exclusive PCM signal playback mode)
Decoding and playback are only performed when PCM
signals are being input.
Note that noise may be generated when using this
mode to play signals other than PCM signals.
e DTS (exclusive DTS signal playback mode)
Decoding and playback are only performed when DTS
signals are being input.
r ANALOG (exclusive analog audio signal playback
(Remote control unit)
mode)
The signals input to the analog input jacks are decoded
and played.
t EXT. IN (external decoder input jack selection mode)
The signals being input to the external decoder input
jacks are played without passing through the surround
PCM DTS circuitry.
NOTE:
• Note that noise will be output when CDs or LDs
recorded in DTS format are played in the "PCM"
(exclusive PCM signal playback) or "ANALOG"
(exclusive PCM signal playback) mode. Select the
AUTO or DTS mode when playing signals recorded in
(Remote control unit)
DTS from a laser disc player or CD player.
3
5
2
and playback are performed