Operation; Before Operating - Denon AVR-2803 Bedienungsanleitung

ENGLISH
(2) Resetting the punch through setting
1
Press the power ON/SOURCE button and the
OFF button at the same time.
• The LEARNED/TX indicator flashes.
2 Press the 1 (play) button.
• TV and DBS/CABLE mode buttons and
LEARNED/TX indicator flash.
3 Press the mode button of the equipment (TV or
DBS/CABLE) that is to be reset.
• The CD, CDR/MD, TAPE, DVD/VDP, and VCR
mode buttons and LEARNED/TX indicator will
flash.
4 Press the mode button of the equipment that is
to be reset again.
• During the resetting operation, the selected
mode button and the LEARNED/TX indicator
will light; they will return to steady state upon
completion.
22
9

Before operating

1 1
1
3, 4
2
2
3
4

OPERATION

Refer to "CONNECTIONS" (pages 4 to 8) and
check that all connections are correct.
Select "AMP mode" using the TAPE,
CDR/MD or CD button. (only when operating
with the remote control unit)
(Remote control unit)
Turn on the power.
Press the POWER operation switch (button).
ON/STANDBY
Lights
(Main unit) (Remote control unit)
• ¢ ON/STANDBY
The power turns on and "ON/STANDBY"
indicator is light.
Several seconds are required from the time
the power operation switch is set to the "¢
ON/STANDBY" position until sound is output.
This is due to the built-in muting circuit that
prevents noise when the power switch is
turned on and off.
Set the power operation switch to this
position to turn the power on and off from the
included remote control unit (RC-925).
• £ OFF
The power turns off and "ON/STANDBY"
indicator is off.
In this position, the power cannot be turned
on and off from the remote control unit (RC-
925).
The front speakers switch as shown below
each time the FRONT SPEAKER button is
pressed.
(Main unit) (Remote control unit)
FRONT A FRONT B
FRONT A+B
3 4
3
2
4