H) Switching On The Control/Receiver Unit; I) Attaching And Fastening The Car Body - Reely Cyclone Bedienungsanleitung

h) Switching on the control/receiver unit

Switch on the control/receiver unit (switch position "ON", see figure in chapter 9e).
The motor then emits beeps for function control.
The beeps are generated by a short actuation of the motor by the controller/receiver unit.
Beep
One short beep
Two short beeps
One long beep
An LED on the control/receiver unit acts as a function display:
LED
LED stays constant
LED off
LED flashes 1x per second
LED flashes quickly
Check the drive and steering functions. For example, move the steering wheel (1) left and right, or carefully move the
throttle/brake lever (2) for forwards/reverse driving.
If the vehicle drive starts even though the throttle/brake lever on the transmitter is in the neutral position
(centre position), move the "TH TRIM" control dial (11) on the transmitter until the motor stops.

i) Attaching and fastening the car body

Now put the car body on the brackets and fasten it with the safety clips that were removed at the start.
44
Meaning
Battery type "NIMH" is set
Battery type "LIPO" is set
Transmitter signal and correct neutral position have been detected, control/re-
ceiver unit is ready for operation
Meaning
Transmitter signal has been detected, control/receiver unit is ready for operation
Transmitter signal has not been recognized (e.g. transmitter is switched off)
Drive battery weak/empty
Binding process