Charging The Drive Battery For The Vehicle - Reely Cyclone Bedienungsanleitung

7. Charging the drive battery for the vehicle

The drive battery is, as a general rule, empty on delivery and must be charged. Several full charge/dis-
charge cycles are required before the battery reaches its maximum capacity.
The drive battery is charged using the supplied USB charger.
Warning!
Do not connect the USB cable to the USB port of a computer/notebook or USB hub because their current
is not high enough for charging.
Use, for example, a commercially available USB power adaptor that provides an output current of at least
1 A.
Only charge the Li-ion drive battery using the supplied USB charger or alternatively using a high-quality Li-
ion charger with balancer. Never use an unsuitable charger. Otherwise, there is a risk of fire and explosion!
Never recharge the rechargeable battery unattended. When charging the drive battery, place it on a fire-
proof fixed base, e.g. a flagstone.
Follow the steps below:
• Separate the drive battery from the vehicle, completely disconnect the plug. Remove the drive battery from the
vehicle.
• The drive battery (A) has a two-pin T-connector (B) and
a 3-pin XH connector (C).
Connect the drive battery to the corresponding socket
(D) on the USB charger (E) using the three-pin XH plug.
Do not use any force.
• Connect the USB charger with a suitable USB power
adaptor (output 5 V/DC, min. 1 A), then plug it into a
mains socket.
• A red LED on the USB charger indicates the charging
status.
LED is on = Battery is charging
LED is off = charging has been completed (or no battery is connected)
With a completely empty rechargeable battery, the charging process lasts approximately 4.5 hours.
• Once the charging process has been completed, disconnect the Li-ion drive battery from the USB charger. Discon-
nect the USB charger from the power supply.
39