Cleaning And Maintenance; A) General Information - Reely Cyclone Bedienungsanleitung

The vehicle moves in the opposite direction to the steering wheel on the transmitter
• Enable the steering reverse function on the transmitter, see section 11. f).
The drive function runs in the opposite direction of the control lever on the transmitter
• Usually, the vehicle should move forwards when the control lever on the transmitter is pulled towards the handle. If
this is not the case, activate the reverse setting for the drive function on the transmitter, see section 11. e).
The vehicle does not steer properly or the steering angle is too low
• Check the dual rate setting for the steering function, see section 11. b).
• Check the steering mechanism for loose parts.
The vehicle moves too slowly
• Check the dual rate setting for the driving function, see section 11. a).

16. Cleaning and maintenance

a) General information

Before cleaning or care, the vehicle and then the transmitter must be switched off and the drive battery removed from
the vehicle.
After you have finished using the vehicle, remove all dust and dirt (e.g. using a clean long-haired brush and a vacuum
cleaner). Compressed air aerosols can also help to remove dirt.
Do not use cleaning aerosols or conventional household cleaners. These may damage the electronic
components and discolour the plastic parts or chassis.
Never wash the vehicle with water, e.g. with a high-pressure cleaner. The will damage the vehicle.
Use a soft, slightly damp cloth to wipe the chassis. Do not rub too firmly, as this may result in scratch marks.
In addition, always check the vehicle for damage before and after each use. If there are any signs of dam-
age, discontinue use immediately.
54