orbit controls OCM191 Betriebsanleitung Seite 46

Orbit Controls AG
*WAI
Description: This command prevents the Calibrator from executing any further
*RST
Description: This command resets the Calibrator to its initial state.
*TST?
Description: This command launches an internal self-test and returns the self-test
*STB?
Description: This query command returns a number representing the STB register
*SRE <value>
Description: This command sets the Service Request Enable register. Since bit 6 is
*SRE?
Description: This query command returns the Service Request Enable number.
*ESR?
Description: This query command returns the contents of the Event Status Register
*ESE <value>
Description: This command programs the Event Status Enable register bits.
*ESE?
Description: This query command returns the value in the Event Status Enable
*CLS
Description: This command clears the Event Status Register and the Status Byte
Betriebsanleitung
commands or queries until all previous remote commands have been
executed.
results ("0" = pass or "1" = fail).
contents. The STB register carries the MSS bit status.
not used, the maximum value is 191.
and clears the register.
Parameter value is a number in the range of 0 – 255.
register.
Register with the exception of the MAV bit and output queue. The
output line is not reset.
OCM191 Isolation Tester - Kalibrator
46