orbit controls OCM191 Betriebsanleitung Seite 43

Orbit Controls AG
[SOURce] : DPP:RES0(?) < DNPD >
Description: This command sets R0 in DPP mode.
Parameters: <DNPD>
Example:
Query:
[SOURce] : DPP:CDAR(?) < DNPD >
Description: This command sets coefficient for parameter DAR in DPP mode.
Parameters: <DNPD>
Example:
Query:
[SOURce] : DPP:CPI(?) < DNPD >
Description: This command sets coefficient for parameter PI in DPP mode.
Parameters: <DNPD>
Example:
Query:
[SOURce] : DPP:CPR(?) < DNPD >
Description: This command sets coefficient for parameter PR in DPP mode.
Parameters: <DNPD>
Example:
Query:
[SOURce] : DPP:ROUT?
Description: Returns the actual output resistance in the DPP mode.
Query:
[SOURce] : DPP:RCO?
Description:
Query:
[SOURce] : DPP:VOLT?
Description: This command returns the measured voltage on the output terminals.
Query:
[SOURce] : DPP:TOT?
Description: This
Query:
Betriebsanleitung
DPP:RES0 1.25E+7 R0 in DPP mode is set to 12.5MΩ
DPP:RES0?
DPP:CDAR 5.853
DPP:CDAR?
DPP:CPI 5.853
DPP: CPI?
DPP: CPR 5.853
DPP: CPR?
DPP: ROUT? Returns the value of the actual output resistance.
Returns the counted resistance value R0*coefficient for the DPP mode.
DPP: ROUT? Returns the value of the actual output resistance.
DPP:VOLT?
Returns the measured total time.
DPP:TOT?
OCM191 Isolation Tester - Kalibrator
Resistance value in ohms.
Returns the value of the R0.
Number without unit.
cDA in DPP mode is set to 5.853
Returns the value of the cDA.
Number without unit.
cPI in DPP mode is set to 5.853
Returns the value of the cPI.
Number without unit.
cPR in DPP mode is set to 5.853
Returns the value of the cPR.
43