orbit controls OCM191 Betriebsanleitung Seite 40

Orbit Controls AG
Command
*IDN?
*OPC
*OPC?
*WAI
*RST
*TST?
*STB?
*SRE <value>
*SRE?
*ESR?
*ESE <value>
*ESE?
*CLS
SCPI Command Details
The following sections give a detailed description of each command.
Using the OUTPut Commands
Remotely controlling the application of the output signal to the Calibrator's output
terminals is accomplished through the OUTPut command. Table IX gives a summary
of the Calibrator's OUTPut commands.
OUTPut[:STATe](?) <CPD> {ON | OFF | 1 | 0}
Description: Similar to the front panel's OUTPUT ON/OFF key, this command will
apply or remove resistance or capacitance decade to or from the Calibrator's output
terminals.
Parameters:
Query:
Using the SOURce Commands
Setting up functions that generate an output are controlled through the SOURCE
command set. Table X gives a summary of the Calibrator's SOURce commands.
Betriebsanleitung
Common Command Summary
Tab XIV. SCPI Common commands
<CPD> = ON or 1 Output signal applied
OFF or 0 Output signal disconnected
OUTP? Returns "ON" or "OFF" to indicate application of output signal.
OCM191 Isolation Tester - Kalibrator
Description
Returns manufacturer, model number, serial number
and firmware revision number.
Sets the OPC bit in the Event Status Register.
Returns "1" when all pending operations are complete.
Prevents the Calibrator from executing command or
queries until all previous remote commands have been
executed.
Resets the Calibrator to its initial status.
Starts a Calibrator self test and returns "0" for pass and
"1" for fail.
Returns value in the Status Byte Register.
Sets the Service Request Enable register.
Returns value in the Service Request Enable register.
Returns value in Event Status register.
Sets the Event Status register.
Returns value in the Event Status Enable register.
Clears the Event Status register.
40