orbit controls OCM191 Betriebsanleitung Seite 41

Orbit Controls AG
[SOURce] :MODE(?)
Description: This command returns the selected mode of the calibrator.
Query: MODE? Returns one of the following functions:
[SOURce] :HVR[:LEV] (?)<DNPD>
Description: This command sets value of the resistance decade.
Parameters: <DNPD>
Example:
Query:
[SOURce] :HVR:VOLT?
Description: This command returns the measured voltage on the output terminals.
Query:
[SOURce] :HVR:CURR?
Description: This command returns the measured current flowing through the
Query:
[SOURce] :TIM[:LEV] (?)
Description: This command returns measured time.
Query:
[SOURce] : TIM:VOLT?
Description: This command returns the measured voltage on the output terminals.
Query:
[SOURce] :SHOR[:CURR] (?)
Description: This command returns measured current.
Query:
Betriebsanleitung
HVR – High resistance source mode
DPP – Dielectric and polarization parameters mode
PSP – Programmable simulation of polarization/absorption
mode
HVC – High voltage capacitance mode
SHORT – Short current mode
TIM – Timer function mode
Resistance value in ohms.
HVR 1.25E+7 High resistance source mode with 12.5MΩ
HVR? Returns the value of the selected resistance.
HVR:VOLT?
selected resistance.
HVR:CURR?
TIM? Returns the value of measured time.
TIM:VOLT?
SHOR?
OCM191 Isolation Tester - Kalibrator
Returns the value of measured current.
41