Images In The Operating Loop; Controller Screen 1, Controller Screen 2 And Controller Overview - JUMO DICON touch Kurzanleitung

5.5

Images in the operating loop

Start screen
After switch-on, the globe appears until the device software is started up.
Then Controller screen 1 appears (default setting).
Using the icon in the bottom right-hand corner, all the images defined in the operating loop can
be called up one after another.
For the screen settings see B 703571.0 - Chapter 12.10 "Screen", page 106
To view the images displayed see B 703571.0 - Chapter 12.10.4 "Operating loop", page 108
5.5.1

Controller screen 1, Controller screen 2 and Controller overview

You can change the color of these screens in the setup program.
The basic structure cannot be changed however.
default
Fixed-setpoint controller and Controller 1 are set up.
In order to function properly, the controller requires an actual value, a setpoint value, and an
output to influence the actual value (for example, a heat source via a relay as a two-state con-
troller). Self-optimization can only detect new parameters using a closed control loop.
Chapter 12.6.3 "Self-optimization controller", page 82
If lines or arrows appear, check the configuration or the connection.
Chapter 11 "Error and alarm messages", page 63
Enter setpoint values on the device for the fixed-setpoint controller
Chapter 8.4 "Setpoint values", page 52
Enter setpoint values for the fixed-setpoint controller with the setup program
Chapter 8.4 "Setpoint values", page 52
5 Operation
35