Program Controller - JUMO DICON touch Kurzanleitung

5.5.2

Program controller

TIP!
This screenshot is not available by default and only appears if the extra code for the program
controller is enabled and configured.
Chapter 2.1 "Order details", page 11
default
There are no programs available. The following options are available for ordering a program:
Enter setpoint curves on the device
Chapter 7.1.1 "On the device", page 43
Enter setpoint curves using the setup program
Chapter 7.1.2 "About the setup program", page 44
Start, Stop
The black arrow starts an available program. A request appears asking which program should
be started and the programmed setpoint curves are then synchronized for both controller chan-
nels. The symbol for automatic operation appears in the center. Touching the black rectangle
stops the program, adopting the conditions prior to the program starting.
Pause
Pauses the time base of a program in operation, whereby the current setpoint values and the
conditions of the control contacts are maintained. Touching the pause button again resumes
program operation.
Next section, previous section
The program in operation jumps to the next or previous section.
Temporary alteration
Allow one-time changes to the setpoint values for a program without storing it permanently in
the program table. When you next run the program, the original setpoint values will be reacti-
vated.
Start/stop manual mode (for program controller)
Manual mode is performed exactly as for a fixed-setpoint controller.
5 Operation
37