Configuration; Analog Selector - JUMO DICON touch Kurzanleitung

NOTE!
The parameters described in this section can be edited using either the setup program or DI-
CON touch. A detailed description of the parameters you can find in the operating manual
B70.3571.0.
Depending on the configuration, signals which are not in use are grayed out.
Functions available in both selectors are highlighted in a specific color.
9.1

Analog selector

The analog selector contains all analog signals available in the configuration dialogs of a tree
structure in the DICON touch.
All analog signals are shown in the following table. The entry in the "Type" column indicates the
source of the signal:
• Internal: Internal signal for the DICON touch (including signals from the analog inputs)
• External: External input, for example, one that can be transmitted via an interface
Category
No function
Analog inputs
External
analog inputs
Mathematics
Controller 1
Controller 2
Signal
Analog input (IN8)
Analog input (IN9)
Analog input (IN10)
Analog input (IN11)
External analog inputs 1 to 8
Mathematics 1 to 8
Actual value for Controller 1
Setpoint value, Controller 1
Controller differential, Controller 1
Output level display, Controller 1
Output 1, Controller 1
Output 2, Controller 1
Cascade output level, Controller 1
Actual value, Controller 2
Setpoint value, Controller 2
Controller differential, Controller 2
Output level display, Controller 2
Output 1, Controller 2
Output 2, Controller 2
Cascade output level, Controller 2

9 Configuration

Type Description
No signal selected
Internal Measured values for analog
inputs 1 to 4
Siehe 609.5Example to set
Analog inputs IN8, IN9, IN10,
IN11
Exter- Analog value for the external
nal analog input 1 to 8
Siehe 13512.18External ana-
log inputs
Internal Result of mathematical function
1 to 8
Siehe 13012.15Mathematics/
logic
Internal
Siehe 7712.6.1Controller
configuration
55