Controller/Parameter Blocks - JUMO DICON touch Kurzanleitung

8 Parameterization
Parameter
Start DST
End DST
8.3

Controller/parameter blocks

Setup dialog
The following table shows the parameters in a parameter block. These parameters are also
available for the other three parameter blocks. Four parameter blocks can be defined for each
of the two controller channels. Switching the parameter blocks is performed separately for each
controller channel via two digital signals.
Depending on the controller type configured, certain parameters may be omitted or ineffective.
Parameters that appear in pairs such as Proportional band 1 and 2 refer to the first and second
controller outputs (for instance, with three-state controllers).
The parameter blocks are assigned to both controllers in the configuration level.
B 703571.0 - Chapter 12.6.2 "Controller inputs", page 80
48
Setting
Month: March
Week: last week
Day: Sunday
Time: 02:00:00
Month: October
Week: last week
Day: Sunday
Time: 03:00:00
Description