Herunterladen Inhalt Inhalt Diese Seite drucken

Digital Selector - JUMO DICON touch Kurzanleitung

Vorschau ausblenden Andere Handbücher für DICON touch:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

9 Configuration
Category
Setpoint values
Program setpoint Program setpoint 1, 2
Section end val-
ues
Flags
Service
Sampling rate
9.2

Digital selector

The digital selector contains all digital signals that are available in the configuration dialogs of
a tree structure in the DICON touch.
All the digital signals are shown in the following table. The entry in the "Type" column indicates
the source of the signal:
Internal: Internal signal for the DICON touch (including digital input signals)
External: External value is transferred via the interface, for example
Category
No function
Controller 1
Controller 2
56
Signal
Ramp end value, Controller 1
Setpoint specification, Controller 1
Setpoint value 1 to 4, Controller 1
Ramp end value, Controller 2
Setpoint specification, Controller 2
Setpoint value 1 to 4, Controller 2
Section end value 1 to 2
Flags 1 to 8
Terminal temperature
Sampling rate
Signal
1st output, Controller 1
2nd output, Controller 1
Self-optimization, Controller 1
Manual mode, Controller 1
Controller 1, off
Controller cycle alarm 1
Output level alarm 1
1st output, Controller 2
2nd output, Controller 2
Self-optimization, Controller 2
Manual mode, Controller 2
Controller 2, off
Controller cycle alarm 2
Output level alarm 2
Type
Description
Internal Setpoint value for controller
channel 1 to 2
as fixed setpoint controller
Siehe 9312.6.6Controller set-
point values
Internal Setpoint value for controller
channel 1 to 2
as program controller
Siehe 11612.12Program con-
troller
Internal
Internal Analog value of the analog flag
Siehe 13212.16Flags/service
Internal Measured value (internal Pt100)
Internal Measured value, sampling rate
Type
Description
No signal selected
Internal Switching outputs, Controller 1
Logic level "0", function inactive
Logic level "1", function inactive
Siehe 7712.6.1Controller
configuration
Internal Switching outputs, Controller 2
Logic level "0", function inactive
Logic level "1", function inactive
Siehe 7712.6.1Controller
configuration

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis