Mounting; Mounting Site And Climatic Conditions; Environmental Influences; Electrical Data - JUMO DICON touch Kurzanleitung

3.1

Mounting site and climatic conditions

The mounting site should be free from vibration, dust and corrosive media. Install controllers
as far away as possible from sources of electromagnetic fields, such as those created by fre-
quency converters or high-voltage ignition transformers. Conditions at the mounting site must
correspond to the following environmental influences:
3.1.1

Environmental influences

Ambient/storage temperature range
Resistance to climatic conditions
3.1.2

Electrical data

Voltage supply
Connection
Voltage
Power consumption
Inputs and outputs
Connection
Conductor cross section
Electrical safety
Electromagnetic compatibility
Interference emission
Interference immunity
Memory data recorder
When recording:
4 analog signals
3 digital signals
3.1.3

Case

Site Altitude
Case type
Front frame dimensions
Panel cut-out
Close mounting
-5 to +55 °C/-30 to +70 °C
Humidity 3K3 (DIN EN 60721-3-3) with extended temperature
range,
rel. humidity ≤ 95 % mid-year without condensation
At the back via screw terminals
AC/DC 24 V +30/-25%, 48 to 63 Hz or AC 110 to 240 V +10/-15 %,
48 to 63 Hz
At voltage supply 230 V: max. 15 VA / 7 W
At voltage supply 24 V: max. 12 VA / 9 W
At the back via screw terminals
2
Max. 2.5 mm , wire or strand with end sleeve
According to DIN EN 61010-1
Overvoltage category III, pollution degree 2
According to DIN EN 61326-1
Class A - For industrial applications only
Industrial requirements
Memory cycle
1 s
5 s
10 s
60 s
maximum 2000m above sea level
Plastic front frame with metal case barrel (for indoor use only)
96 mm × 96 mm
+0.8 0.8
92 mm × 92+ mm according to DIN IEC 61554
Spacing between the panel cut-outs, min. 35 mm horizontally and
min. 80 mm vertically
Recording interval
approx. 44 days
approx. 220 days
approx. 441 days
approx. 2646 days (7 years, 91 days)

3 Mounting

17