Bernette london2 Bedienungsanleitung Seite 46

2 3 5
Securing a seam (beginning
EN
and ending the seam)
Beginning the seam
Place fabric approximately 1cm (1/2") inward
from the outer edge under the presser foot.
Press the reverse sewing lever (A) while
sewing backwards up to the fabric edge.
Release reverse sewing lever and continue
sewing.
End of seam (1)
At the end of seam, press down the reverse
sewing lever (A). Sew a few reverse stitches.
Release the lever and the machine
will sew forwards again.
Removing the work (2)
Turn the handwheel towards to bring the
thread take up lever to its highest position,
raise the presser foot and remove the work
towards the back.
Cutting the thread (3)
Cut both threads with the thread cutter (B)
located on the left rear side of the face plate.