Inhaltsverzeichnis
Werbung
2
3
5
EN
Threading the upper thread
Caution:
7XUQ SRZHU VZLWFK WR 2 EHIRUH WKUHDGLQJ
or unthreading the machine.
- To release the upper thread tension the
SUHVVHU IRRW OHYHU KDV WR EH UDLVHG
7KH WKUHDG WDNHXS OHYHU PXVW EH LQ WKH
highest position when threading.
1. Place spool on pin using appropriate
spool disc (spool turns clockwise). Take
thread through rear guide (A) and then
into slit of upper thread tension.
* Note:
,I XVLQJ VSHFLDO WKUHDG ZKLFK ZLQGV TXLFNO\
RII WKH VSRRO DWWDFK D QHW WR WKH VSRRO EHIRUH
using and use the larger spool holder.
(YHQWXDOO\ UHGXFH WKH WKUHDG WHQVLRQ DV ZHOO
2. Pull thread down to the right of the cover
around point (B).
3. Take thread up to the left of the cover,
placing it in the take-up lever (C).
4. Take thread down and through guide (D).
Insert the thread through the eye of the
needle from front to back.
5. Leave about 10 cm (4") of thread loose
behind the needle, or cut the excess
thread by using the thread cutter (E).
Werbung
Inhaltsverzeichnis
Fehlerbehebung
