Low Battery Indicator - 3M Speedglas 100 Bedienungsanleitung

1 ï
Sensitivity setting (Speedglas 100V only)
The sensitivity of the photo detector system (which responds to the
light from the welding arc) can be adjusted to accommodate a variety of
welding methods and workplace conditions. In order to see the current
sensitivity setting, momentarily press the SENS button. To select another
setting, press the SENS button repeatedly until the LED shows the desired
setting.
Position 1
Position 2
Position 3
If the filter does not darken during welding as desired, increase the
sensitivity until the welding filter switches reliably. Should the sensitivity
be set too high, the filter may remain in the dark state after welding is
complete due to ambient light. In this case, adjust the sensitivity downward
to a setting where the welding filter both darkens and lightens as desired.

Low battery indicator

The batteries should be replaced when the low battery indicator flashes or
LEDs do not flash when the buttons are pressed.
WARNING
Should the Speedglas 100 welding shield fail to switch to the dark state
in response to an arc, stop welding immediately and inspect the welding
filter as described in these instructions. Continued use of a welding filter
that fails to switch to the dark state may cause temporary vision loss. If the
problem cannot be identified and corrected, do not use the welding filter,
contact your supervisor, distributor or 3M for assistance.
MAINTENANCE
Replacement of outer protection plate.
Remove front frame. (see figure C:1)
Remove the used outer protection plate and place the new outer protection
plate on the welding filter. (see figure C:2)
Front frame must always be used (see figure C:3).
4
Least sensitive setting. Used if there is interference
from other welders' arcs in the vicinity.
Normal position. Used for most types of welding
indoors and outdoors.
Position for welding with low current or with stable
welding arcs. (eg TIG welding)