Battery Change - Simons Voss Technologies KU SmartHandle Kurzanleitung

Battery cHange.

1. optional: depending on the centres distance, it may be necessary to disassemble the cylinder first.
2. carefully insert the battery replacement tool into the inside fitting inlay from below.
3. detach inlay and carefully push towards the handle.
4. also push inside cover towards the handle.
5. carefully unlock the electronics and fold back horizontally.
6. carefully remove both batteries from the holder.
insert the new batteries into the holder at the same time with the positive poles next to each other;
7.
change the batteries as quickly as possible. You must wear clean gloves free of fat or grease to handle
new batteries.
8. carefully click electronics back into place.
9. use the tool to push the slider on the inside of the inlay back to its home position; if you do not, the inlay
can no longer be clicked into place.
10. push the inside cover back into position, so that it is fitted flush with the door.
11. insert inlay and lock into position in the inside cover.
Battery cHange on smart HanDle – HyBriD.
In SmartHandle – Hybrid, there are not only batteries in the inside fitting (see "Battery replacement" for more details),
but there are also other batteries in the outer fitting. You must always replace all batteries at the same time.
1. optional: depending on the centres distance, it may be necessary to disassemble the cylinder first.
2. carefully insert the battery replacement tool into the outer fitting inlay from below.
3. detach inlay and carefully push towards the handle.
4. also push outer cover towards the handle.
5. carefully unlock the electronics and fold back horizontally.
6. carefully remove both batteries from the holder.
insert the new batteries into the holder at the same time with the positive poles next to each other;
7.
change the batteries as quickly as possible. You must wear clean gloves free of fat or grease to handle
new batteries.
8. carefully click electronics back into place.
9. use the tool to push the slider on the inside of the inlay back to its home position; if you do not, the inlay
can no longer be clicked into place.
10. push the outer cover back into position, so that it is fitted flush with the door.
11. insert inlay and lock into position in the outer cover.
15