Simons Voss Technologies KU SmartHandle Kurzanleitung Seite 13

8. remove inside fitting from the door.
9. drill the holes with a diameter of 8 mm (top hole) and 13 mm (lower hole) through the door.
10. insert outer handle horizontally into the outer fitting, placing it in the direction that you require, depending
on whether it is a din left-hand or right-hand door.
11. place handle fastener piece into position (see diagrams 2 and 3)
12. Hold the outside handle and use the spanner to rotate the fastener piece about 75° to the right until it fits
into position (diagrams 4 and 5). if you do not fit it correctly, the handle may come loose again.
13. the inside fitting is mounted onto the inner surface of the door. push the inner fitting spindle through the
mortise lock retainer slot and push the inner fitting onto the door until it is about 5 cm away.
14. insert the two spacing bolts in the outer fitting. on the smartHandle Hybrid, the upper spacing bolt is
already attached.
15. push the cable from the outer fitting through the lower hole (13 mm in diameter) and through the opening
in the cable escutcheon. ensure you do not catch or buckle the cable while doing so.
16. push the outer fitting retainer slot onto the spindle while pushing the two spacing bolts through the drill
holes in the door. when doing so, pull the cable of the outer fitting taut on the inside, ensuring that the
cable of the outer fitting is not caught or kinked.
17. connect the 2-pole cable of the outer fitting with the 3-pole cable of the inside fitting. this cable can only
be inserted in one direction. do not pull on the cables while doing so; just carefully secure the plug-in
connection into position.
18. the second 2-pole cable from the inside fitting can hang freely, but must not get caught or buckled when
the outer cover is fitted. do not pull on the cable. the second cable is optionally used to connect the
wavenet circuit board.
19. press outer and inside fittings together, so that they both are flush against the door.
20. click the electronics module in the inside fitting carefully out of its bracket and fold back horizontally.
make sure that the electronics are not subject to mechanical load and are not damaged in any other way.
21. insert the supplied screws through the inside fitting drill holes from inside the door and fasten to the outer
fitting spacer bolts by hand (about 5-7 nm). ensure you do not squash the 2-pole cable when doing so.
22. carefully click the electronics back into their bracket.
23. check that the outer handle can turn easily; if it does not, there may be a problem with the mortise lock
or the handle may have been fitted incorrectly. in case of doubt, disassemble components and start again
from step 10.
24. push inside handle onto the inner tube until it will go no further.
25. tighten the inside handle hex screw firmly by hand (about 5-7 nm).
26. push the cylinder through the designated hole in the fitting from the outside. in doing so, ensure that the
cam is at the six o'clock position and that the 3-pole cable does not get caught or buckled.
27. fasten the cylinder with the fastening screw by hand (about 5-7 nm) – note that cylinder and screw are
not part of the supply.
28. push cover over the inside handle.
29. carefully push the inlay through the opening in the inside cover.
30. push cover onto the inside fitting, so that it is flush with the door. the cover is not symmetrical – please
pay attention to the marking.
31. click the inlay carefully into the cover.
32. push cover over the outer handle.
33. carefully push the inlay through the opening in the outer cover.
34. push cover onto the outer fitting, so that it is flush with the door. the cover is not symmetrical – please
pay attention to the marking.
35. click the inlay carefully into the cover.
13