Alarm Forwarding And Alarm Stop - pyrexx PX-1C Betriebsanleitung

10.1 Cancelling a device from a
radio group
You must cancel a device from a radio group in
the following cases:
Removing device from an
•
existing radio group and
connecting it to another group
Removing the defective device
•
from the radio group
In the radio group from which the device
was removed, you must set all the devices
to factory settings and re-connect them:
f Observe chapter 6.1 "Setting up the
radio group" on page 61.
f Observe chapter 7 "Expanding a
radio group and learning mode" on
page 63.
f Observe chapter 6.2 "Completing a
radio group" on page 62.
66
Operating Manual: PX-1C - Smoke Alarm Device with Radio Link
11 Alarm forwarding
and alarm stop
Alarm forwarding takes place in two direc-
tions with the following forwarding times:
Alarm forwarding within a
•
radio group or a shared radio
group = approx. 20 seconds.
Alarm forwarding from
•
the radio group to the shared
radio group = approx. 60 seconds.
There is no alarm forwarding from the
shared radio group to the individual ra-
dio groups.
Repeater function
Through the repeater function, radio sig-
nals are forwarded from one signalling
device through available devices to un-
reachable devices.
If you need specific and/or
c o m p l e x c o n n e c t i o n f u n c -
tions for the alarm forwarding,
please contact the manufacturer
(see chapter 15 "Accessories, spare
par ts and product suppor t" on
page 75).
EN
EN