pyrexx PX-1C Betriebsanleitung Seite 62

To add a fur ther device, proceed as
follows:
(5) Push the split pin down sideways off
the activation button.
(6) Press the activation button so that
it is flush. The devices connect
automatically.
Short acoustic signal
5 The device has successfully con-
nected.
(7) To add additional devices, repeat
steps (5) and (6) on each further
device.
With each newly added device,
the learning mode star ts a new
10 minute period.
62
Operating Manual: PX-1C - Smoke Alarm Device with Radio Link
6.2 Completing a radio group
To end the learning mode of a radio
group, you have two options:
f Wait 10 minutes (learning mode
ends automatically) or
f Press the radio button briefly on any
device:
Signal LED "off "
f The radio group is in operation.
Signal LEDs of all the ra-
dio groups participants also
go out.
f To test, perform a connection test
(see chapter 9.1 "Radio group con-
nection test" on page 64).
EN
EN