pyrexx PX-1C Betriebsanleitung Seite 57

(3) Press the magnet carrier firmly for about
10 seconds at the mounting position.
(4) Take the device into operation and set
it up.
f Observe chapter 6 "Initial commission-
ing and setting up" on page 60.
(5) Position the device on the magnet
carrier.
5 The device is mounted on the
magnet carrier.
The ultimate strength of the adhe-
sive bond is achieved after about
72 hours.
Adhesive mounting according
to EN 14604:2005/AC:2008
and vfdb 14/01 (Q)
To establish a permanent connection
between the device and magnet carrier
EN
EN
Operating Manual: PX-1C - Smoke Alarm Device with Radio Link
(e.g., as theft protection), you can addition-
ally mount the device with the supplied
adhesive film on the magnet carrier.
CAUTION
Possible property damage!
Mounting the device in accordance
with vfdb 14/01 (Q) establishes a
permanent connection between
magnet carrier and the device. Thus,
a subsequent removal of the device
is prevented. The start-up and set up
of the device are no longer possible.
If the device is disassembled, it can
cause damage to the device and the
mounting surface.
f Use the additional adhesive film
only to prevent theft.
f Put the device into operation
and set it up before attaching the
additional adhesive film.
57