Auerswald COMfortel 1200 IP Inbetriebnahmeanleitung Seite 40

Preparation
– Receiver connected
– Network cable connected (see
Hold the drilling template onto the area where the device is to be mounted
1.
and place marks where the two mounting holes are to be drilled into the
wall.
Important: Make sure that there are no electrical leads, gas or water con-
ductions in the section where you want to drill the holes.
Drill the mounting holes (diameter 5 mm) and insert dowels into the holes.
2.
Screw the two screws far enough so that the screw head is about 5 mm
3.
away from the wall.
Mount the telephone on the screws, then slide the telephone on the wall
4.
downwards until the screws hit the stopper.
40
page 41)
COMfortel 1200 IP - Setup V03 09/2016