Auerswald COMfortel 1200 IP Inbetriebnahmeanleitung Seite 42

Commissioning
i
Fig. 10: Connection via PoE Injector
A PoE Injector
B Network switch
C COMfortel 1200 IP
If required, insert the PoE Injector into a freely accessible network mains
3.
outlet.
Note: If the message Get IP is shown on the display, this indicates that the
DHCP server is missing.
 Configure the network settings manually (see
Further Steps
 Automatic configuration (provisioning server) (see
42
In a network that does not support PoE: Plug in the other plug of the
network cable into the socket labelled LAN of the PoE Injector. Use the
additional network cable to connect the socket labelled PoE of the PoE
Injector to the socket labelled
C
The telephone starts up. In the meantime, the Auerswald company icon
is shown on the display.
If a DHCP server has been configured in the local network, the tele-
phone automatically receives its IP address, subnet mask, as well as
the gateway and DNS server addresses from this DHCP server during
a DHCP request.
on the bottom of the telephone.
A
LAN
page 44).
page
COMfortel 1200 IP - Setup V03 09/2016
B
43)